Pingo – About the Printer
We are thrilled to bring to you Pingo, our 3D Printer! Large Build Volume Pingo boasts an impressive 200x200x200mm build volume – large by the standards of even much more expensive printers. To put that into perspective, if you were to print a hollow box as large as you could, it […]
A batman bust in carbon fiber PLA, 100 micron layer height. Turned out excellently!
The “To make or not to make” skull from thingiverse (thing:441087). This print was well over 20 hours but it turned out perfectly! The support material generated by slic3r did an excellent job, and the complex overhangs and under surfaces are well formed.
A completely functional printed ball bearing, all in one print! White PLA at 200 micron layer height.
This great elephant model prints in one go and then stands up! It has joints at the front legs, back legs, and head. Printed in gold PLA from Ultimachine.
Sprial Chess Piece
This awesome model (thing:470700) was printed in white PLA at 0.2mm layer height. The print was done without support, and turned out flawlessly. Enjoy!
A really neat moai (thing:149271) printed at a 100 micron layer height in orange PLA. An absolutely flawless print, try to find any layer lines!
A print in the coffee HTPLA from Proto Pasta. This is a really cool material, and it even smells like coffee! The print is a single-perimeter rocket (thing:458903) in spiral vase mode at 0.2mm layer height.
A great looking tiki statue (thing:33746). Layer height of .2mm, printed in wood PLA. Wood filled PLA is very fun to work with and turns out looking great!
Rusty Pirate Coin
A really neat print showing off the multi-material capability of our printer. We used Magnetic Iron PLA from Proto Pasta, which is a filament with iron particles embedded in it. The print came out flawlessly, and afterwards the rusted effect was created with water, salt, and hydrogen peroxide. Overall a great […]